free volume

英 [friː ˈvɒljuːm] 美 [friː ˈvɑːljuːm]

自由体积

化学



双语例句

  1. An integral melting equation was derived according to free volume theory.
    根据液体的自由体积理论导出了高压熔化的积分表达式。
  2. The relationship between the film forming and the free volume of the emulsion paint is discussed. Meanwhile, several methods of preparing the VOC-free emulsion paints are given.
    讨论了乳胶漆的成膜性与自由体积的关系,并介绍了制备零VOC乳胶漆的几种方法。
  3. Rather than one expanding into a free volume, and we're going to open a barrier between them and see them mix.
    不再是从一个扩散到另一个自由体积,而是我们将要撤走两种气体之间的隔板,然后看它们混合。
  4. The positron annihilation technique was applied to study the relation between relative free volume and irradiated graft for PTFE.
    用正电子湮没技术研究在聚四氟乙烯辐照接枝过程中的自由体积与正电子湮没寿命谱的关系。
  5. The mechanism of the deformation and fracture of the alloy was analyzed by using the free volume model.
    采用自由体积模型对非晶合金的形变和断裂的微观机制进行了分析。
  6. Effects of toughening agent and temperature on the free volume and mechanical properties were studied by positron annihilation lifetime spectroscopy ( PALS) and dynamic mechanical analysis ( DMA) for a serious of epoxy resin samples with different toughening agent content ( W/ W).
    用正电子湮没方法(PALS)和动态力学分析(DMA)方法研究了增韧剂和温度对环氧树脂的自由体积和力学性能的影响。
  7. On the basis of the free volume theory, the equation of state for liquids is discussed.
    由自由体积理论研究了液体状态方程。
  8. So the morphology and the free volume of PU should have some relation with their electrical insulating properties.
    由此可见,PU的形态结构与自由体积特性和材料的电性能密切相关。
  9. The free volume theory is also applicable to the NMR relaxation in polymers.
    自由体积理论在NMR弛豫中也是适用的。
  10. The novel image measurement and analysis with computed digital tomography have been developed for the polymer morphology of solid conveying, which is based on the relation of polymer free volume and the stress and strain.
    基于聚合物自由体积理论和应力应变关系,提出了对固体输送中聚合物形态进行计算机层析图像测量和形态特征提取与分析的新方法。
  11. The theoretical models consist of three categories: free volume, hydrodynamic, and obstruction effect models.
    水凝胶中扩散理论模型主要有自由体积模型、流体力学模型、位阻效应模型三大类;
  12. The mass transfer of binary aqueous solutions through pervaporation membrane was studied. A modified solution-diffusion model was established based on Flory-Huggins solution theory and Fujita ′ s Free Volume theory.
    对二元水溶液在渗透蒸发膜中的传质过程进行了研究,基于FloryHuggins高分子热力学理论和Fujita自由体积理论建立了改进的溶解扩散模型。
  13. Free volume and VOC-free emulsion paint
    自由体积和零VOC乳胶漆
  14. The curing shrinkage mechanism of UP resin were analyzed with free volume theory.
    本文用自由体积理论分析了不饱和聚酯树脂的固化收缩机理,理论计算与实验测定结果基本一致。
  15. The results showed that the average radius of free volume holes maintained constant on the whole in development.
    结果表明:明胶的自由体积空穴的平均尺寸在显影过程中基本保持不变。
  16. The deformation of hydraulic concrete can be classified as load-induced deformation and free volume deformation.
    本文将水工混凝土变形分为荷载变形和自由体积变形两大类。
  17. Freedom; The free volume contribution to the excess Gibbs energy for the solvent-polymer solutions was taken into account.
    考虑了自由体积效应对溶液的过量Gibbs自由能的贡献。
  18. The relation between free volume and the character of γ irradiated graft in PTFE
    γ辐照接枝聚四氟乙烯特性和自由体积的关系
  19. A Prediction technique for gas permeability from polymer structure has been developed on the basis of free volume and molar cohesive energy.
    本文利用基团加和法,对20多种常见聚合物的自由体积和内聚能进行了计算。
  20. Diffusion Coefficient Model Based on Potential Energy and Free Volume
    基于扩散势能和自由体积的扩散系数模型
  21. Amplitudes of macromolecular motion and free volume
    高聚物的分子运动幅度和自由体积
  22. This phenomenon is explained by free volume and viscosity theo-ry.
    用粘度和自由体积理论解释了此现象。
  23. Influence of interfacial polarization and size of free volume hole on positronium formation
    界面极化和自由体积尺寸对正电子素形成的影响
  24. A new model of self-diffusion coefficient is invented by the introduce of a new expression of free volume.
    通过引进新的自由体积表达式,提出了新的自扩散系数模型。
  25. On the basis of the free volume model and the entropy model for the viscous flow, the proposal would be made of that the viscous flow behaviour of the metallic glasses is related to their thermal stability and degree of short-range order.
    用粘滞流变的自由体积模型和熵模型对结果进行了解释,并认为粘滞流变行为与金属玻璃的稳定性及短程有序化程度有关。
  26. Meantime, rolling creates more free volume.
    同时,轧制变形导致了更多自由体积的产生。
  27. In this paper, the effect of pressure on Tg of NBR was simulated. The influences of probe radius ( Rp) and pressure on free volume was studied.
    本研究通过分子动力学模拟方法研究了不同压力对丁腈橡胶Tg的影响,同时探讨了探针半径Rp和压力对自由体积的影响。
  28. The thermal stability and hydrophilicity of the membranes were enhanced and the free volume characteristics were improved, simultaneously.
    膜的热稳定性和亲水性也由于BHA颗粒的掺入而明显提高,自由体积特性得到改善。
  29. The free volume increased as the Rp and pressure decreased.
    自由体积随Rp和压力的增大而减少。
  30. The acoustic absorption mechanism of free volume was brought forward and was validated by experiment.
    提出并验证了自由体积吸声机理。